BMW E30 limited slip differential, 3.25 ratio, Rebuilt to factory 25% lockup. This is a fully rebuilt E30 limited slip differential set up for an E30 specifically, but will all E28 5 series and E24 6-series (cover is for'83-84), except the M cars. Fits all 6 cylinder E30s, the E30 M3, and E23 7-series cars from about'82 on. Fits 6 cylinder Z3 models.This is the medium size case with a 188 mm ring gear, E30 side flanges and E30 rear cover. For anything other than an E30, you just have to swap the rear cover and perhaps the pop-in drive flanges. Includes differential, side drive flanges, and media blasted rear cover as shown. This unit was professionally rebuilt. This means everything was disassembled, cleaned, and parts were replaced as necessary. The carrier spool was rebuilt using 2 good used clutches (inspected and media blasted) and set up to the stock 25% value.
New bearings and seals were installed and the unit was setup correctly to ensure proper and long term operation. The yellow paste on the gears is to show the contact pattern between the ring and pinion gears. The unit weighs approximately 90 lbs when boxed up. Thanks for checking this out.Powered by SixBit's eCommerce Solution. The item "BMW E30 3.25 ratio OEM 2-Clutch Type 188 REBUILT Limited Slip Differential LSD" is in sale since Tuesday, February 23, 2021. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Transmission & Drivetrain\Differentials & Parts".
The seller is "aardvarc" and is located in Bonita, California. This item can be shipped to United States, Canada.